(1.6 NA) Valve retainer angle

804 Views 8 Replies 3 Participants Last post by  Laguna96
Does anyone know the angel of the cone where the retainers sit in?
I already googled it but found nothing. Maybe I didn't searched hard enough.
1 - 1 of 9 Posts
just pull one out of your head or a junkyard head and measure it yourself. its not something you will find on alldata/prosis/mitchell so you wont likely find it here. the retainer has to match up with the keepers and if you plan on making keepers then they have to match up with the valves.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.