ClubRoadster.net banner

1 - 6 of 6 Posts

·
Registered
Joined
·
323 Posts
Discussion Starter #1
would it be safe to remachine new holes into a wheel? there's a set of wheels I want that are perfect offset as is, but it's 4x114.3 rather than 4x100.



has anyone gotten wheels remachined before? is there anything I should know about remachining wheels?
 

·
Registered
Joined
·
1,797 Posts
It can be and has been done, I know coz i did it but it depends largley on the mounting pad behind the wheel...most wheels have pockets machined/casted out between mounting holes. If those are solid then it can be done.
 
1 - 6 of 6 Posts
Top