ClubRoadster.net banner

1 - 7 of 7 Posts

·
Registered
Joined
·
321 Posts
Discussion Starter #1
Just got another miata to replace the one I wrecked, and it came with an alarm and a remote. Has the loudspeaker/megaphone thing + a motion detector unit mounted inside + on/off (I assume) toggle switch. With the remote there are only two buttons, one with 1 dot and another with 2 dots. I've figured out that if I hold the one with 1 dot down, it will make the alarm go off. But I can't figure out how to arm is so that if movement is detected the alarm will go off. Anybody have any ideas?
 

·
Registered
Joined
·
200 Posts
Most alarm remotes work by just pressing the button with 1 dot (left), to arm and disarm. The second button, with 2 dots (right), controls any options the alarm may have like turning off the chirp.
 

·
Registered
Joined
·
321 Posts
Discussion Starter #5
Well there is a unit between the seats mounted above the center console box. It has a red/green LEDs that are like motion detectors...
 
1 - 7 of 7 Posts
Top