ClubRoadster.net banner
41 - 46 of 46 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter · #43 ·
removing and prepping for paint. All the rust was removed by dipping the parts in some sort of mixture. Dont know what was used in that bath, because i sendt the job away. Cleaned and Painted everything, so nice to install now :giggle: Looking forward to new bushings

Automotive tire Motor vehicle Asphalt Rolling Tints and shades


Motor vehicle Gas Automotive exterior Bumper Automotive tire

Automotive tire Motor vehicle Hood Tread Wood


Automotive tire Motor vehicle Road surface Grey Asphalt


Removing some rust from the diff too, gave it some paint
Automotive tire Wood Road surface Gas Motor vehicle

Wood Automotive tire Gas Machine Auto part

Automotive tire Wood Flooring Road surface Gas
 

·
Registered
Joined
·
76 Posts
Discussion Starter · #44 ·
Very cold outside now som had to let the paint dry inside in the basement :) little mix of black and gray just to show that something has been done without screeming red or yellow colours.
Motor vehicle Wood Gas Vehicle Automotive exterior

Automotive tire Motor vehicle Automotive exterior Font Automotive wheel system

Sewing machine Wood Motor vehicle Gas Sewing machine feet


Started to install some, subframe and swaybar with polyurethane, ready for the diff and ppf :geek:

Hood Motor vehicle Automotive tire Tire Automotive exhaust

Motor vehicle Automotive tire Asphalt Bumper Electrical wiring

Automotive tire Motor vehicle Wood Bicycle part Automotive exterior
 

·
Registered
Joined
·
76 Posts
Discussion Starter · #46 ·
It’s so cold now and i dont have any heating system in the garage so the progress is a bit slow. Installed meister R and one driveshaft. And now i got a good deal on a slightly used Flyin miata stage 1 clutch, so the ppf and driveshaft have to go out again so i can take down the transmission :rolleyes: :giggle: I dont know what brand of the clutch thats installed now and i slipping on a bad thay some times. I did order a few parts to the clutch change, oilseal crankshaft, oil seal and gasket to the input shaft. And a o-ring for the CAS
Automotive tire Hood Motor vehicle Bumper Automotive exterior
 
41 - 46 of 46 Posts
Top