ClubRoadster.net banner

1 - 19 of 19 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I have a 95' miata and it's lowered on racelands with ISC tophats.Trying to fit some 15x8 +0 wheels(already have em) and I was wondering what camber most people were running to fit them that have a small pull?I will be running 195/45/15's and car is at about 11" hub to fender height in rear,haven't measured front.Car is already at -3 in rear,don't remember what front was when I got it aligned but it wasn't much,only like -1.x.Also how much negative camber can you run in the front without having to get offset bushings is another one of my questions,any help would be greatly appreciated.
 

·
Registered
Joined
·
1,389 Posts
XDXDXDXD:lol::lol: some one lost it already! bout time!
 

·
Registered
Joined
·
527 Posts
yes i have, but considering a good portion of this forum is into "fitment" i would search. literally his answer is on the first page of the fitment thread. that is why i am not cutting him any breaks.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #7
yes i have, but considering a good portion of this forum is into "fitment" i would search. literally his answer is on the first page of the fitment thread. that is why i am not cutting him any breaks.
Cool story bro.Tell it again sometime and I'll probably not give a **** then either.
 

·
Registered
Joined
·
748 Posts
In before ban...? :phillyb:
 

·
Registered
Joined
·
1,389 Posts
15x8 +0 no need for lots of camber or pull, so mount those puppies and rock'em like is your last day.



.... and yes your questions where answered in the "fitment thread" and "the picture fitment thread" HUNDREDS OF TIMES. If you had asked for a 205 tire on those wheels, maybe people would have been nicer because only 2 that I know off have done it. Everybody else, goes for a 194/50 or 45 on a 15x8+0. There you have it.
 

·
Registered
Joined
·
2,887 Posts
yes i have, but considering a good portion of this forum is into "fitment" i would search. literally his answer is on the first page of the fitment thread. that is why i am cutting his breaks.
:eek:
 

·
Registered
Joined
·
1,389 Posts
^^ hahahaha didn't notice he was out for murder-1. lol.
 

·
Registered
Joined
·
748 Posts
1 - 19 of 19 Posts
Top