1 - 1 of 1 Posts

· Supporting Member #5522
3,960 Posts
Discussion Starter · #1 ·
im converting to a inline low psi fuel pump to feed my twin carbs. im thinking about running the Carter P4594. i will put it in the engine bay, however i don't know what to do with the stock fuel pump. i puled it out today to look at it and there's a flange that the fuel pump goes into. i don't know what to do, i thought about cutting it off and extending the line and putting a filter on the end however if i don't keep my set up and want to go back to the stock fuel pump i dont want to cut it off.

here is a pic i found but you can see the flange

this is what i want to do
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.