ClubRoadster.net banner

1 - 10 of 10 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter #1
This might be a weird request, but does anyone here have a dxf file for NA frame rails? I'm quite keen to get some made over here.

Cheers
Dave
 

·
Registered
Joined
·
65 Posts
Just have someone measure their length of frame rail and profile then you can make a dxf easily no?
 

·
Registered
Joined
·
62 Posts
Discussion Starter #6
ask flying miata for dxf of butterfly brace??

IF anyone can be bothered removing their brace, or has one lying about, could they please measure up the lenghts and hole spacings? That would be primo aswell!
 

·
R U ?
Joined
·
7,169 Posts
Hole spacing really shouldn't matter all that much... just as long as it isn't like this [. :. : ] If it means that much to you.. I'll get my measuring tape, walk into my garage, measure my frame rails, and give you some measurements.
 

·
Registered
Joined
·
62 Posts
Discussion Starter #10
Has anyone been able to measure theirs? By quick measure under my car I assume the basic dimensions for the frame is 1200(L)x65(W)x40mm(high). anyone able to verify?
 
1 - 10 of 10 Posts
Top