ClubRoadster.net banner

1 - 12 of 12 Posts

·
Supporting Member
Joined
·
455 Posts
Discussion Starter #1
Killer deal if you're in the Portland area. 35$ for up to 3 pulls, horsepower, torque, air/fuels, boost/vac graphs.


 

·
Supporting Member
Joined
·
455 Posts
Discussion Starter #8
Not running mine but it'll be behind the garage door in the showroom. Its getting some new sensors installed for ethanol. Just finished the interior and dynomat gut and it'll be going under the knife for some serious weight reduction and a cage in the next couple days. The engine bay is still neat to look at in the meantime. If i'm not around ask whoever is up front to open the door if you guys want to check it out. I wont be there all day. (my day off)
 

·
Supporting Member
Joined
·
455 Posts
Discussion Starter #9
I'll post my results for sure after i finish this series of small projects. Not sure if i've updated my build thread on CR.net but its up to date on MT.net. ~300 wheel, dry sump, efr6758, new bottom mount manifold.

 

·
CSTG
Joined
·
3,229 Posts
Very nice Yank, and sorry I couldn't meet up with you tonight.

I'd be there, but I really need tuning time, not pulls. Maybe the NB could put down some pathetic numbers, but I won't have the K&N filter for it yet :evil:
 

·
Big Pimpin'
Joined
·
8,505 Posts
I might show up so see if I can even spin the drums.
 
1 - 12 of 12 Posts
Top