ClubRoadster.net banner

1 - 14 of 14 Posts

·
Murse Magnet
Joined
·
7,241 Posts
Discussion Starter #1
Ok i got an r lip and i have read many installs on it. My problem is that the little flaps that look to channel air. How do they attach. My under tray has no mounting place for it. I was thinking removing part of the tray and drilling a small hole in it to attach a screw threw it. Maybe you guys have a better alternative. Thanks
 

·
Murse Magnet
Joined
·
7,241 Posts
Discussion Starter #3
mine came with just 4 small screws and 4 nuts. I got the lip used. Are self tapping screws something i can get at home depot.
 

·
Murse Magnet
Joined
·
7,241 Posts
Discussion Starter #6
is there a particular length i need. I do not want this to go too far in and mess up something important.
 

·
Registered
Joined
·
91 Posts
My r lip kit came with nearly a dozen bolts and nuts. The lip mounting required drilling a hole every 4 inches or so. If u have an oem bumper, there will be 4dimples where the holes are to be drilled.

Regarding the 4 screws, two are for mounting below on the corners of the splash guard, the remaining two are used at the ends of the lip. Good luck.
 
1 - 14 of 14 Posts
Top