ClubRoadster.net banner

1 - 11 of 11 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter #1 (Edited)
For sale are a set of MazdaSpeed side sills. I bought them to try and mod them to fit my MX-3 but they are too short and wide, and I would rather not cut them up as they are in pretty nice shape.

I live in WA, 80.00 USD plus shipping

Thanks for looking

 

·
Supporting Member
Joined
·
3,007 Posts
Not to thread jack but more helping you out. I bought mine off ebay for around 75 dollars. Yeah one side was scuffed up.
 

·
Banned
Joined
·
734 Posts
Not bolt-in but can be hacked up on the backside so that they sit flush enough to fit. I didn't hack off enough plastic so I have two gouges on each side. Make sure you hack off enough plastic! Then it is just 3M double sided tape.
 

·
Registered
Joined
·
47 Posts
Discussion Starter #6
OK OK looks like I may be asking a bit too much. No thread jack, I would do the same. I guess my loss is your gain. I did have OBO in there :)

So 120 shipped, gets them.

They would have worked in my MX but I would have had to bend them a bit and cut and rework the outer edge. Not worth damaging them for that.
 

·
Registered
Joined
·
47 Posts
Discussion Starter #8
I am only trying to sell. I purchased them for an experiment on my MX3 and they will not fit. Thanks for the the offer though.
 
1 - 11 of 11 Posts
Top