ClubRoadster.net banner

1 - 20 of 63 Posts

·
Sequence Number 1280
Joined
·
3,052 Posts
Discussion Starter #1 (Edited)
We are currently tearing down Tony's miata, so we have parts up for sale. We are NOT PARTING OUT the car, we are rebuilding it, next phase!

---------------------------------------

94-95 Turbo "Kit"

NA8 Intercooler setup:
2.5" piping on both cold side and hot side
Cold side has pipe for IAC
Cold side has bung for IAT
Comes with all silicons and t-bolt clamps
Designed for HKS manifold with t25/28
^no AC/PS

Blitz Blow Off Valve
-New Venturi Drive

Intercooler
^Core 21.5" x 9.5"
^^Overall 28" x 9.5"

Turbo 3" downpipe
-custom 2piece
--v-band setup
-no divorce

Turbo 3" exhaust setup
-fully custom
--two resonators
---quiet large muffler
--electronic exhaust cutout

Only parts needed to complete the turbo setup of how it was originally on tony's car are:
--t25/t28 turbo
--HKS manifold
--oil/water lines

Original cost of parts:
Aluminum Intercooler Pipes: $350
Intercooler: $100
BOV: $200
Downpipe: $300
Exhaust piping: $150
Resonators: $150
Muffler: $60
Electronic Cutout: $150
Total: $1460

Price: $700

The setup above with a CXRacing T28 boosting 14lbs with the MSPNP and 550 injectors (for sale too) netted 250hp (94-95 na8). OEM fuel pump used. Boosted over 100k miles.

----------------------------------------

SOLD

5spd transmission
Still bolted to engine
Will pull when bought

$200

SOLD

----------------------------------------

ON HOLD FOR LEONARD

6spd transmission
-was going into the car after rebuild
--change of plans
---unsure of condition, but should be good
--Came off JDM 99-00

$700

ON HOLD FOR LEONARD

----------------------------------------

Torsen rear-end Type 2
-2002 SE
--4.3 gear
---Complete with axles and driveshaft
--off the drift-car, heavily used

$600

----------------------------------------

Torsen Type 2
-Came off same 99-00 as the 6-speed
-complete with axles and driveshaft
-was our backup set (can be used to swap for another miata)

$650

----------------------------------------

SOLD


na8 motor
-off Tony's car
--Ran GREAT
---Never any problems
--Timing belt/water pump 8k
-140k, 50k boosted
--ACT Clutch and Flywheel
---6 puck sprung Heavy Duty
---Prolite 10.4lb
---^8k with 2 drift events
--NGK Power Cable set
-oil pan tapped for turbo

$600

SOLD

----------------------------------------

MSPNP for 94-95 NA8
-off Tony's car

$550

550CC Red-top Injectors

$150

Both: $600


----------------------------------------

OEM Hood with pins
-Rustoleum paint

$75

----------------------------------------

OEM Fenders
-rolled and pulled
--to fit 16x8 et0 w/ 205-40-16
-Rustoleum paint
--includes fender markers

$150 for both

----------------------------------------



9998 by terry pham, on Flickr


----------------------------------------

Pictures of all parts at:
http://www.flickr.com/photos/terrypham/

----------------------------------------

If you want more than one part, we can make a deal.





.
 

·
Hide yo kids hide yo wife
Joined
·
6,286 Posts
goddamn it Terry... stop parting dope cars!

Also - i'd have bought your engine if i known it was for sale earlier =[
 
1 - 20 of 63 Posts
Top