ClubRoadster.net banner

1 - 12 of 12 Posts

·
CR.net Supporter
Joined
·
242 Posts
Discussion Starter #1 (Edited)
Garrett turbo / RM DP / 2.5-inch catback w/Magnaflow single pipe

FOR SALE - Local Pick Up in Tampa, FL - Shipping Extra

[1] Garrett turbo from a Nissan CA18DET motor - $150.00

Oil & water-cooled. No shaft play and spins freely.

[2] Racing Mazda 2.5-inch mild steel downpipe with flex section and flange to fit [1] above - $100

There is surface rust that can be cleaned with a wire brush and prepped for paint or coating. RM DPs had a tendency to crack around the flange welds and bends and this DP has been repaired an welded in the past. The welds aren't pretty, but there were no leaks when last used.

[3] 2.5-inch cat-back mild steel exhaust with Magnaflow muffler and single exit exhaust. Exits at stock location - $100

[4] (SOLD)1.8L cast iron turbo manifold w/T25 flange (possibly HKS?) - $125










 

·
CR.net Supporter
Joined
·
242 Posts
Discussion Starter #6

·
CR.net Supporter
Joined
·
242 Posts
Discussion Starter #8

·
CR.net Supporter
Joined
·
242 Posts
Discussion Starter #9
I also have a complete DP-back 2.5" exhaust with catalytic converter and a Magnaflow single-exit muffler that fits with this turbo and DP setup ($100). I was saving it for use in another turbo setup I am building, but I opted for another exhaust.
 

·
CR.net Supporter
Joined
·
242 Posts
Discussion Starter #10
Update Bump: Marked manifold as sold and added description for cat-back exhaust.
 

·
CR.net Supporter
Joined
·
242 Posts
Discussion Starter #11
Boost bump. Somebody must need some on the cheap! :)
 

·
CR.net Supporter
Joined
·
242 Posts
Discussion Starter #12
Bump!

No reasonable offers refused! :)
 
1 - 12 of 12 Posts
Top