ClubRoadster.net banner

1 - 6 of 6 Posts

·
Registered
Joined
·
436 Posts
Discussion Starter #1
Hey guys, I have a 55W 6000k DDM Tuning HID kit I just put in. I'm getting some flickering issues where it appears once after the bulbs have reach operating temperature they begin to flicker rapidly and consistently. If i turn them off for a minute or two, then back on they are solid for about 20 seconds and then continue flickering. If i shut the car off, they're solid. Does anyone know what may cause this?

Thanks
 

·
Accepting donations.
Joined
·
3,366 Posts
Are both flickering?

If its only one swap ballasts and see if the one is shot.

Check all your grounds most likely a bad one.
 

·
Registered
Joined
·
436 Posts
Discussion Starter #3
good thinking. switched them around, same kit is causing the flickering. So a new ballast should fix this yes?
 

·
Registered
Joined
·
433 Posts
Ummm well for one ddm is cheap and pretty much crap. Works, but is crap.
Your not going to want to hear it because apparently your headlights are not Woth actually spending money on.
Retrofit source is good.
Can also get good things on hid planet
 
1 - 6 of 6 Posts
Top