[Full-Bore Motorsports]

Has anyone done this in thier Miata? I have an extra one sitting around and my origional on is looking pretty tired. And the red stitching would look good with my car. Thanks for your help.

 

[imez2miss]

There were issues with the way it fits cause it is so tall. What I did was remove the old boot from the pegged plastic piece it was on. I cut the elastic string from the bottom of the new boot so I could stretch it further. Then with an exacto I cut four holes in the bottom of the boot just behind the elastic string seam. I hooked those holes in paris on to opposite sides of the plastic piece and put it back in.

You are gonna have to finess the boot a bit cause it wrinkles pretty bad. I just tucked the boot inside itself so it look a little better.

 

[denny]

Here's a few links ...

http://www.augerresources.com/sishiftboots.htm

The Si boot in Alcantara is the same as their black suede that you can order for a Miata.

http://www.augerresources.com/miatashiftboots.htm

I haven't used them yet but I posted their link for the meter cover and everyone seemed to say they were good quality.