ClubRoadster.net banner
1 - 15 of 15 Posts

· RDR
Joined
·
4,304 Posts
its doable, just take it to an exhaust shop, depending how deep or sticking out of the bumper you want it would depend how gnarly of a bend the piping is gonna be.
you should prob chop off the hangers and clean that area up btw
 

· Registered
Joined
·
245 Posts
Discussion Starter · #4 ·
its doable, just take it to an exhaust shop, depending how deep or sticking out of the bumper you want it would depend how gnarly of a bend the piping is gonna be.
you should prob chop off the hangers and clean that area up btw
Any idea of how much it will cost?

is it for a miata? or universal?
Reread what you just asked, It's for my 1996 Miata.
 

· Registered
Joined
·
245 Posts
Discussion Starter · #14 ·
Had this exhaust on my civic years back. Didn't like the sound of it at all. But then again, it was on a civic...
I used to own a 2001 civic.. Didn't like it at all.. Besides the gas mileage haha

I had an Apexi N1 catback on my RSX for a short time.. It was super loud and raspy.
I'm hoping it sounds good on my Miata..

good find
Thank you:) It was originally put up for 150 but I got the owner to lower his price.. a lot.. Haha
 

· Rehabilitation Officer
Joined
·
15,461 Posts
Pretty good deal. Those mufflers go for 200 bucks (at least the 80mm ones do). Just make sure you get good piping and a resonator if you are not turbo. Just a bullet muffler on the midpipe if you are turbo. Will keep down rasp and still be loud
 
1 - 15 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top