1 - 6 of 6 Posts

· Supporting Member
832 Posts
Discussion Starter · #1 ·
I recently aquired a complete set with about a foot of wiring per side.
Wiring will not be an issue.

What size hole do you make for these to fit? Looking at the back, I am not quite sure if it is a round hole.
ANY help woth regards to hole size, a template, etc., would be greatly appreciated!

· Founder
4,599 Posts
Randy has the EXACT measurements for correct placement on the fender with regards to the beltline, etc.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.