ClubRoadster.net banner
1 - 5 of 5 Posts

·
Registered
96 Miata
Joined
·
61 Posts
Discussion Starter · #1 ·
Suggestions on how to mount these?
I bought one pair to do in front of rear wheels.
Rust hole in driver rocker I am going to weld or panel bond a patch over. Already have the patch made.
Then I want to install these over the patch.
They are plastic, urethane, abs? I dunno for sure.
How can I hold them in place if I use panel bond adhesive until the adhesive sets?
The photos are from several different ads for the flares.

150426


150427

150428
 

·
Registered
96 Miata
Joined
·
61 Posts
Discussion Starter · #3 ·
I wish I was done.
I live in PA and don't have a garage so they will need to wait until spring.
 

·
Registered
96 Miata
Joined
·
61 Posts
Discussion Starter · #5 ·
No rubbing issues as they fit tight up against the factory wheel well lip.
 
1 - 5 of 5 Posts
Top