1 - 1 of 1 Posts

102 Posts
Discussion Starter · #1 · (Edited)
Picked up a 91 over the weekend. It was rear-ended. Impact wasn't too bad, but there is some damage. Crushed the finish panel and bumper. Looks like the worst of the impact was on the right side, into the rear bumper support. The bumper support and end of the frame section got tweaked down a little bit. Kind of hard to get a picture of it, but I think you can see the kink pretty clearly. Also looks like the sheet metal behind the finish panel is pushed in a little bit (left side in the pic).

I'm obviously getting a new rear bumper and finish panel. But any ideas on on how to fix the bumper support & sheet metal?

Update: Got it fixed


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.