ClubRoadster.net banner

1 - 7 of 7 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
I'm parting out my 1991 Mazda RX7 with 120000kms and remembered the injectors are used for turbo builds here.

This is the injectors part number:



I'm looking for $85 shipped.

I'm located in Ontario, Canada.
 

·
Registered
Joined
·
4,998 Posts
Forgive my ignorance but these are plug and play for 1.6 and 1.8 Miata's? If my calculations are correct then they will support approx. 234hp(460cc/10.5= 43.8 lbs/hr x 80% duty cycle / .6 B.S.F.C= 58.4 hp x 4 inj. = 233.6 hp), someone correct me if i am wrong. If so i will take them for the asking price of $85. :icon_cheers:
 

·
Registered
Joined
·
2,139 Posts
These are plug and play for miatas. Can't remember off my head if it's low impedence or high that we need, but whatever it is, these are the same. I run these in my car, ~70% duty cycle for over 200whp.

Recommend getting used injectors cleaned/flowed before using them.

-Ryan
 

·
Registered
Joined
·
4,998 Posts
These are plug and play for miatas. Can't remember off my head if it's low impedence or high that we need, but whatever it is, these are the same. I run these in my car, ~70% duty cycle for over 200whp.

Recommend getting used injectors cleaned/flowed before using them.

-Ryan
Thank you good sir! PM sent to OP. :icon_cheers:
 

·
Registered
Joined
·
40 Posts
Discussion Starter #7
Sold! I looked for a way to lock the thread, but I assume there isn't? (rx7club I just click on "thread tools")
 
1 - 7 of 7 Posts
Top