ClubRoadster.net banner

1 - 7 of 7 Posts

·
Registered
Joined
·
299 Posts
Discussion Starter #1
ok well i went to my local junk yard to get a 1.8 rearend swap well the miata was striped already. but i saw a bunch of 7s . so what all can i use from the seven? for 206 i can get the dif axles and drive shaft. what else will i need to make it work? also how can i tell what rx7 has a lsd and which are open?????

sorry if this is in the wrong spot
 

·
CR.net Supporter
Joined
·
1,390 Posts
you can use everything from an fc rx7 N/A except for the front part of the diff which you would have to source from a miata (the fc one is too long).

to tell if the diff is open or torsen or clutch, pull the cover off, and go to the solo miata site for what is what.
 

·
Registered
Joined
·
299 Posts
Discussion Starter #5
so could i use these parts and would it work?
86-91 NA RX-7 rear housing
86-88 NA RX-7 stub shafts
86-88 NA RX-7 LSD
79-85 RX-7 or RWD 626 or B2000/2200 short pinion gears.
94-95.5 Miata halfshafts
94-01 Miata driveshaft
 
1 - 7 of 7 Posts
Top