ClubRoadster.net banner

1 - 8 of 8 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter #1
I have done my research and I know they fit in a miata NA.

I can't find any info as to how they will mount.

I know a lot of you would recommend fixed back seats, however, I am only 5'7 and sit relatively closer when I drive. Therefore, a reclining seat would fit my needs a lot better.

Now my question is, if they will mount on stock rails? Or do I need something custom?
And I don't want to weld, nor do I want to sit too much higher than stock.

Thanks in advance.
 

·
Registered
Joined
·
605 Posts
Brix2 uses the Bride RO rail.

Keep in mind while the seat will bolt in there's a very good chance that the recline knobs will hit the door or the trans tunnel.
 

·
Registered
Joined
·
98 Posts
YOU might be able to use teh FO, just dont use the SIde mounts since they're detachable from the actual rails/brackets.
 
1 - 8 of 8 Posts
Top