ClubRoadster.net banner

1 - 10 of 10 Posts

·
CR.net Supporter
Joined
·
1,390 Posts
craigslist?
the junkyard?

Depends on what kinda shortblock.
shortnose crank ones are cheaper

I've seen them go from like 50 bucks up. You can get a used JDM engine for around 400.
 

·
Registered
Joined
·
559 Posts
Discussion Starter #3
How much of a beast is it to replace rings, bearings, and pistons?
How much does a hone normally cost?
 

·
Registered
Joined
·
559 Posts
Discussion Starter #9
I want a stong lower because I have a brand new head. Will 100k last me? Are the rings good? Any leaks?
 

·
Registered
Joined
·
1,688 Posts
From what I have seen 1.6 longblocks go between $250-400 depending on mileage. DO you have any mazda specific recycling yards around there? Maybe try Mazsport in GA. They are a bit on the spendy side but shipping shouldn't be too bad for where you are, and they have a big inventory. Also The Parts Group Might have what you want and they seem to have really good prices. Also in the SE so shipping shouldn't be as bad.
 
1 - 10 of 10 Posts
Top