ClubRoadster.net banner

1 - 5 of 5 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
Hey guys I just replaced all the seals in my head and put a new head gasket on and my car will start but it won't stay running. I made sure to mark my cams and put them in the same way they came out. I have changed the timming on it and it just doesn't want to start and I know it's getting fuel and air and spark. There's is only one thing that I didn't really pay attention to and that was the cam angle sensor and which way the little key was facing when I took the intake cam out. Could that be the problem? Should I take the intake cam out agian and flip the little tap 180 degrees around and try agian?
 

·
Registered
Joined
·
410 Posts
I think the key only goes in one way. Is everything connected vacuum and all that how are your wires. I has the same problem turns out my CAS wires were crusty. Other than that I would try turning it 180 degrees like you said.
 

·
Supporting Member
Joined
·
2,284 Posts
The CAS only goes in one way..the key is offset..so that is not the problem.
 
1 - 5 of 5 Posts
Top