ClubRoadster.net banner

1 - 3 of 3 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
heres the story i was driving one morning and I stepped on the clutch to shift in to gear and felt the clutch pop/snap kinda feeling. I thought it might be a bad master C or the slave and have just replaced them. I bleed them good and it wont go in to gear when the engine is running. My next guess would be the tranny shift lever or something else inside. I only have time on the weekends and its not very much to work on it. Just wonering if anyone has had this problem or know what it could be
 

·
ClubRoadster.net Founder
Joined
·
4,631 Posts
It may be possible that your clutch fork is not engaging the release bearing, but I would check the bottom end of your shift lever first and make sure the urethane ring is not in little pieces in the turret.
 

·
Registered
Joined
·
559 Posts
^^^ do that first.

Is the weather cold? My car does that when it is cold. I have to slam it into gear sometimes.
Does the clutch feel like it is slipping?
 
1 - 3 of 3 Posts
Top