ClubRoadster.net banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,132 Posts
Discussion Starter #1
I noticed that there was some oil pooled in the flange that enters the compressor housing on my GT2560R (coming from the intake filter). I installed a catch can, and this drastically cut down on the amount of oil that was showing up in there, however, there is still some accumulation.
The blades spin very freely, no side-to-side play, very little in-and-out play, so that tells me that it seems to be a normal ball-bearing turbo in good shape, so not bad seals that I can tell, but I'll admit, I'm not an expert on turbos.
Should I be concerned, or should I start looking into rebuilding/replacing a turbo?
Thanks!
 

·
Registered
Joined
·
1,132 Posts
Discussion Starter #3
No pics, sorry.
If this clarifies, I'm talking about the flange on the compressor of the turbo, right where the intake tube (coming from the filter) feeds air into the turbo.
 
1 - 4 of 4 Posts
Top