ClubRoadster.net banner

1 - 20 of 94 Posts

·
Registered
Joined
·
130 Posts
Discussion Starter #1
Hello,
I know some of you started posting what you would like, so I set up a thread for it.
I will be subscribed for this so post away.
Jason
 

·
Senior Member
Joined
·
4,296 Posts
^^ but with a different canister , and a longer Tip after the canister, not angle cut. but angled upward

Fender braces, at competitive prices , like BossFrog.

adjustable Rear Upper control arms to dial out camber .
Like the TC Sportline prototype. ( i dont have a link) search on CR

more cool stuff
 

·
Registered
Joined
·
1,999 Posts
YES!

But make those fender braces more tuckin' than frog. I can't stand the frog ones. Nice simple crossbraced ones.
 

·
Registered
Joined
·
1,017 Posts
Brackets that would allow me to use the calipers from an FC rx7 on the front of my NB.....
 

·
Registered
Joined
·
126 Posts
can you make a really cheap randall intake out of plastic that looks OEM
 

·
CR.net Supporter
Joined
·
374 Posts
ADJ control arms +3!!!
 

·
bad mother f......
Joined
·
3,173 Posts
Coldside cold air intake
gauge pod for top of dash
 

·
Finger lickin' good...
Joined
·
6,605 Posts
3" St.May-style shotgun exhaust w/ minimal bends
 

·
Supporting Member
Joined
·
2,723 Posts
1. Mounts to mount the Outlaw calipers onto stock NA8 or NB sports rotors:
http://www.clubroadster.net/forum/viewtopic.php?t=7783&highlight=outlaw+calipers

2. height adjustable pillowball uppermounts that allow you to adjust the ride height without crawling under the car

3. meter pod that goes on the meter hood (similar to the Garage Vary piece but for LHD obviously). Or a angled double or triple meter pod that goes on the center top of the dashboard location just like Stealth suggested.

4. A tasteful (not crazy outlandish) bolt on extraction vent for the stock hood

5. A tasteful (not crazy outlandish) bolt on extraction vent for the hardtop. It has to include some sort of interior panel also to cover the exposed fiberglass cutout

6. A tasteful (not crazy outlandish) bolt on extraction vent for the side of the fender.

7. An aluminum tank to replace the factory plastic radiator overflow tank.

8. A rear diffuser that goes under the stock (or cut) rear bumper
 

·
Registered
Joined
·
126 Posts
*+3 on the cold side intake, maybe randall type?

*Nopro style ebrake bar (not just handle)

*cheap heat shield

*cheap plastic radiator cover thingy for better flow (for NA)
 
1 - 20 of 94 Posts
Top