[tuned]

I've sold my first miata and have just purchased a replacement. It's being shipped from Japan sometime in the near future and I have a couple weeks to browse the auctions and try and find some pieces to bolt on before it comes over.

My relentless YJ browsing has found me these:

http://tinyurl.com/y79upx - translated
http://page10.auctions.yahoo.co.jp/jp/auction/m31669244 - untranslated

I'm liking the stagger but I don't know if the offset is going to work. The front should be fine but will I have issues with the back? Looking at about 700$ which doesn't seem too bad but I would love if someone could properly translate the page for me. Not sure if I should be worried about "One place [ho] it is with there is the bending of feeling amount".

They're a bit rashed up but if they're straight and will fit I'd love them on my car.

Let me know what you think OR show me some other JDM suggestions. The car is BRG and would look great with some E03's.

 

[tuned]

says seller will not ship internationally....

the seller would not be shipping internationally.

 

[tuned]

Not sure on weight. Hoping they are a pound or two lighter than that but I can live with 15.

Think I could rock these (15x8 +23) without some serious fender beating?

http://page.auctions.yahoo.co.jp/jp/auction/96164003

 

[tuned]

rob. are you saying the 15x7 will be inside the fender or out. I'm hoping that the 15x8 sits flush but I'm getting a little worried. Also hoping that the 45 series (vs. 50 series) makes a bit of difference too.

 

[tuned]

Dale, are you 15x8 +23 in the garage? If so, I'm a happy camper.

Got to say, I love the car. I'm going for a slightly different look but we think alike.