ClubRoadster.net banner
1 - 20 of 26 Posts

·
Registered
Joined
·
1,228 Posts
Discussion Starter · #1 · (Edited)
Work Equip 03s: Immaculate condition, shiny, no rash, no curb, new centercaps, new work valve stems. mounted on BRAND new toyo r888s (seriously, only 10 miles on them)

Front: 15x8.5 3et A-disk Rear: 15x9 7et O-disk, 205/50/15 tires

$1800 or trade for some super wide, or low offset legit wheels, or $1600 without tires























and yes these fit under stock fenders



949 Racing super miata air dam lip SOOOOOOOOOOOOOOOOLLLLLLLLLLLLLLLLDDDDDDDDDDDD

Freshly painted in pirates black with double clear for chip resistance. I have also double reinforced this lip with thick weave mat fiberglass, this thing will take a beating from daily use and survive~ no problem. easy four bolt mounting- two allens on each side, two allens in the smile of the bumper.

Lip actually increases stability as well as looking super intense; i noticed a great reduction in wind buffering at high speed, so it does its job well

will included the 2 front flares that i cut to match it.

$sold









Nardi leather Nb Wheel: will fit both Na/Nb (on na, airbag will not work, without splicing and such), perfect condition, material is nice, no stitch lifting, no fading, everything intact and functional

$115

 

·
Registered
Joined
·
1,228 Posts
Discussion Starter · #9 ·
No, i pulled them down because i was going to keep them for a bit, but i decided on more fat fitment

urinal: i wouldve killed to have your j-lines, im actually using your specs for my next setup as a baseline (hope you dont mind :3)
 

·
BaByGuRL!!!
Joined
·
5,553 Posts
Your car looks great Jeremy! Very tastefully done. Why the part out?
 
1 - 20 of 26 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top