ClubRoadster.net banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,389 Posts
they look deep measure the hole to make sure they will fit.
 

·
Registered
Joined
·
196 Posts
Anyone know the impedence on the factory headrest speakers? I only ask because most car audio systems are designed around 4 ohm speakers, and these are 8 ohms. If you run them in parallel, you should get decent sound. just keep in mind that if the factory system is designed for a different impedance, you may have some volume issues or worst case (not likely) heating of the HU amplifier. That said, it's all low risk, so give it a whack!
 

·
(⌐■_■)
Joined
·
2,307 Posts
the factory system is designed for a different impedance, you may have some volume issues or worst case (not likely) heating of the HU amplifier. That said, it's all low risk, so give it a whack!
You will have volume issues and run the risk of frying the amp.

Remember, a single 4 ohm speaker is the equivalent of two 8 ohm speakers in parallel
 
1 - 5 of 5 Posts
Top